It's a wall mount.

With adjustable angles in 2 axis (one of which depends on the way you mount it on the wall)

It perfectly fits my enclosure for the Waveshare ESP32-S3 LAN CAM.

Since the design is parametric, it can easily be modified to hold any other rectangular thing. Just adjust variables leny_enclosure and lenz_enclosure in the FreeCAD VarSet

Printing

• any material
• layer height: ≤ 0.3mm
• nozzle size: ≤ 0.6mm
• 3 or 4 perimeters (wall strength) depending on nozzle size
• only the clamp's axis can profit from a bit of support. Remember to cut away the remaining support filament, so the axis is round.
• infill: 25% honeycomb

Assembly

1. print
2. make sure the clamp's axis is round. If necessary cut away a bit, so it fits into the wall-mount.
3. slide the ESP32 enclosure into the clamp
4. press the clamps axis into the wall-mount parts at the desired angle
5. connect the two wall-mount parts using the connector.
6. mount using double-sided (gecko-)tape

Alternatively, you can screw the wall-mount in, using the mount-hole and a big washer. In that case, use the connectors first and put in the clamp last.

License

• share as you like, but always with attribution
• remix as you like, but always with attribution