Protective tray and sleeve for the RunCam Split WiFi Module.

Now you can throw the Wifi module in your toolkit without worrying about the pins getting bent.

The sleeve and the tray have 0.4mm of space between them and rely on a friction fit. There are little nubs on the sides of the tray to provide the right amount of friction to keep them together. If it's a little tight after you have printed it, slide the tray in and out a few times and it should loosen up a little.

Anet a8

Doesn't Matter

No

0.2mm

15%

Wall width is 1.2mm which equates to 3 layers with a 0.4mm nozzle, so I had to set my line width at 0.35 and wall line count to 1 layer in order for Cura to add the middle layer and not do two lines separated by an air gap.
No supports required.