A wall bracket to get the Bike Trainer out of the way when it's not in use.

The dimension of the round bar on the trainer is just about 2''/50mm and the rubber ends measure about 2-3/4''/70mm.

I included the FreeCAD file for you to mock with if you want to change things or improve it.

Print Settings

Supports: 

No

Infill: 

35%

Notes:

I printed these in PLA with three walls and 35% infill to get strength and durability. Print them lying flat and the holes will be fine even without support. I've used chamfers for edges and screw holes which should give overhang angles that are comfortably free of support needs for most. Otherwise, add the support - it's only for the screw holes anyway.

Category: Sport & Outdoors