This is a durable case for you new 9 DOF inertial measurement unit (IMU) from Adafruit. I used the IMU found here:
https://www.adafruit.com/products/1714 however others may work as well.

If you don't know what a IMU does visit my site on that has a description of many common sensors.
http://secondrobotics.com/its-all-about-the-sensors/

I printed this on a Formlabs Form 1+, You will need to use a SLA to print the fine detail letters and IMU key diagram.

Enjoy!

Set in the sunlight for a few hours to UV cure

If you want it super clear. You will need to sand down to a very fine sandpaper and use Novus plastic polish or cork.

Solder 4 wires to the following pins:

GND
VIN
SCL
SDA

Feed though wire with hole and carefully align the IMU with the plastic pegs of the bottom case. Seal the wire hole with hot glue or resin/UV light.

Use 3mm hex head screws to hold it together.