This project is created to make an external hard-drive cover mainly for laptop users which can be carry to any place and can be hang on the screen led back (display back) so there is no need to place on the table and forget or the mess while packing or working. i made it to a hard drive (https://www.seagate.com/in/en/products/external-hard-drives/one-touch-external-drives/) which saves place and time. there are holes in the back and front of the 3d printed parts which acts as the air vents, so the hard drive is cooled. place some rubber or adhesive silicone bumper material on the cover led to prevent from the disc from sliding on the display like in the image.

for printing this i have use PLA filament you can use any materials even using resin prints.

note:-

-> if there is a damage of hard-drive in the process or while using it is not your responsibility. so please be careful while fixing and using as it is cover to hold and carry not a damage protector.

-> i have place some rubber like material in between the hard-drive and case to prevent the drive from moving inside in the case (mainly at the corners of the disc and case holder).

material: -

2x5mm screws - 4

2x10mm screws- 4

2x36mm road or wire - 1

Category: 3D Printing