Adaruit has recently released a new sensor board - the CLUE. I wanted a case that held the clue and the standard 3 x AAA battery pack and allowed changing batteries without taking it out of the case. Here is the result.

You can find the CLUE at https://www.adafruit.com/product/4500

I used six 2.6mm x 10mm Pan Head Phillips Screws to attach the cover.

On Cults: https://cults3d.com/en/3d-model/gadget/adafruit-clue-case if you care to support my designs

LulzBot

TAZ 6

No

Doesn't Matter

I used 1.5mm

Any - but I set wall thickness to 2mm for strength

Support may be needed for the diagonal frames around the screen, buttons, and switch. You may be able to print without supports. I printed without and it is a little bumpy, but it is okay for me. The back cover does not need supports.