This is a simple remix at a client's request to shrink the case down to better hold a 2230 sized NVME M.2 form factor SSD module without bouncing around inside it.

As noted from the original, You will absolutely need to use Vase mode (or Spiralize Contour) for it to print hollow.

For Cura, this means:
Inflil: 0% infill
Enable Advanced settings to show Special Settings- Spiralize Outer Contour is hiding there.
Top/Bottom: 0 top layers

Your slicer may vary.

The photo shows the original in the background, and the remix in front.

Creality

CR-6 SE

No

No

.4