USB Power Blocker Case
DirectFjord21
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2025-12-29 20:46:42
0
0
000Descripción
Fuente del modelo
Comentarios(0)
This is a simple case for USB power blocker for 3D printers, OctoPrint, or Raspberry Pi.
Found here: https://www.tindie.com/products/fatmannmakes/usb-power-blocker-inhibitor/
The alignment pins are very small, but I never had an issue printing them. Put a few drops of CA glue on the corners to seal.
Optionally can use some hot glue on both sides of the board.
Fuente del modelo
Enlace original: Ver detalles
CC-BY