Updated V2 here: https://www.printables.com/model/202267

I designed this case to accomodate a raspberry pi 4b and the HDMI camera adapter by Petit Studio (https://www.tindie.com/products/freto/pi-camera-hdmi-cable-extension/), and a 30mm fan. Case has a cutout for the SD card for ease of access.

I reused the screws that came with my old raspi case to hold the board down, and some random tiny screws to hold the hdmi adapter to the inside of the lid. Screw holes are 2mm but might need a slight tickle with a drill depending on your printer tolerances. Fan is fastened by M3 x 15mm bolts and nuts.

I got lazy and couldn't be bothered doing snap fits, and I needed to raise the case off the ground so the cables would clear the lip on the top of my tool chest, so I just made sleeves that hold the case together. I have included the step files in case anyone wants to remix and put snap fits on. Otherwise, the sleeves actually do a good job of holding everything together.

Check out my Pi Cam V2 case that houses the other end of the HDMI adapter kit as well:

https://www.printables.com/model/199731

Category: Electronics