This collection is for a Rasp Camera mounted to the Z-Axis that it can move up as well (helpful if you print higher parts).

In my special case with my Anycubic Mega-S and installed LED-Strip-Holder around the frame i had to create an own holder and a cable guide for the left frame.

UPDATE: i made the screw hole a little smaller that a M3-Screw really fits.
And i made the "gripping" part of the cable guide and holder a little longer.

Camera Box
This is a remix of https://www.thingiverse.com/thing:3121052

I modified the parts a little and removed the letters from the back and the ball-handle from the front.
Instead i placed a small part where a M3 screw will go in for the Z-Axis Holder.

The Holder
I changed the holder itself as i have LED-Strip-Holders everywhere and the cam-holder must go around them.
I was inspired from this one: https://www.thingiverse.com/thing:4286454

This part is screwed with 2 M3x8 with M3 Nuts and Washers to the left Z-Axis cabinet.
I agree, without a helping third hand it is impossible to install it without de-assembling the whole printer and you should have slim fingers. But my wife and i made it in 10 mins.... ;-)

Cable Clip Guide
To guide the cable to the top and back down on the left side to the Pi i created a cable guide which will be attached from the back on the frame on the top left corner by simply pressing it on the frame.
The Clip-part itself is from https://www.thingiverse.com/thing:1037722

Anycubic

All-metal Mega

Doesn't Matter

No

0.1

25%

Print Settings for the "Cable Guide and Clip"

Resolution: 0.2
Infill: 10
Raft: Brim