Rotating TurnTable ESP32-WIFI-WEB interface (28cm diameter)
barbara
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2026-01-18 03:45:07
0
0
000Descripción
Etiquetas
Fuente del modelo
Comentarios(0)
First of all: this is a remake of the amazing: https://www.thingiverse.com/thing:4817279
I made the following changes:
- the table now is bigger : 28 cm of diameter
- I used an ESP32 with WIFI
- I made it an Access Point
- you can access via AP and change: direction and speed
- the switch is round
it is all fully enclosed with 18650 batteries that can be extracted and changes I know it is overkill using esp32, but it was there around doing nothing. the ESP has also a display which I am not using.
You can find also the*.ino file and the html.h one.
I am not very good in HTML5 and css so if you can get it better let me know that I will update it.here you can find it on GitHub: https://github.com/Blu-Eagle/turntable-wifi-esp32
Print Settings
Printer Brand:
Creality
Printer:
CR-10
No
Supports:
No
200
Infill:
20
Filament:
Generic PLA brown and than partially painted black
Notes:
You need a large plate for printing the top which is 28 cm of diameter.
at the same time it is important to have a flexible plate otherwise it will be very difficult to take it out given the large surface that touches the bed.
I suggest 4 perimeters, using for the external one 95% flow and lower speed, in this way you have an amazing smooth result.
about the WIFI:
you will fine an open Access Point to connect: MyESP32AP
then go with the browser to http://192.168.4.1 then you find a slider for the speed and a switch button for the direction.
Etiquetas
Fuente del modelo
Enlace original: Ver detalles
CC-BY