this is a custom lightsaber chassis i made for my lightsaber hilt.
this chassis is made for a little bit smaller lightsabers

it may require some sanding for different parts

this chassis supports:

• 18650 3.7 V battery
• a round recharge port
• a 14mm round button (momentary)
• a proffieboard (not CFX)
• a kill switch
• and places for the battery tabs
• speaker (i dont know what size but i recommend 24mm or less)
• neopixel pcb hilt side (i am going to use the short pin, but you can use long pin if u want)

these are the print times (on my crappy old ender 3 pro):

pcb holder: 3 minutes

chassis: 3 hours and 12 minutes

[WARNING:  THIS LIGHTSABER CHASSIS DOES NOT USE THE NORMAL SPACINGS BETWEEN THE BUTTON/CHARGE PORT, THE SPACINGS ARE A LITTLE BIT BIGGER FOR MY CUSTOM LIGHTSABER HILT. I AM MAYBE GOING TO ADD A NORMAL SPACINGS ONE, BUT FOR NOW: BE AWARE]

:)

PS. if there are any flaws, please contact me