This is a thin lip to go on the edge of a shelf to keep small items from falling off.

It has a 1 or 2 layer 20mm wide flat part that I affix to the shelf with double sided tape. The lip is 5 or so mm tall. The lip is 5 mm on the inside, but has a fillet on the visible side so that if you are looking at the shelf from a lower angle it is almost invisible.

Small enough to not be noticeable on a shelf the same color, large enough to prevent a bump on the shelf to have things come crashing down.

Saves me a lot of anxiety.

The shelf lip is 200mm wide. I have included the fusion files so that you can customize to your needs. I just printed them and snipped the last to fit the shelf, but if you want just extrude or push/pull the edge to the dimensions you want for a perfectly flush install.

Prusa

i3 MK3

No

No

.2

15