߷ Get your spinning ON!

REQUIRED STEPS:

FLIP the caps upside-down in your slicer so that the larger circle is on the bottom. 
Should look like > Ʇ

SET the Perimeter Shells to 1. This will let the pieces fit into each other.

The model is set to INCHES. If the size looks fine by default in the slicer then you're fine.

FOR <30 MIN PRINT: 

Use line infill at 10% infill

POST PROCESSING:

You can glue the caps together or just hold them together when spinning. 

Careful putting the caps together, they may be fragile. 

Have fun and don't forget to ❤!