Wall Hook
sandra_green32
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2024-01-15 00:27:17
0
0
000Descripción
Fuente del modelo
Comentarios(0)
Summary
This is a simple wall hook i modeled to hold some lanyards and medals. i printed this hook at 15% infill and was able to hold well over 200 pounds and even after it fell off it didn't break, a screw just ripped out.
Printed on Ender 3 v3 ke:
25-100% infill
no supports
SCREWS REQUIRED
I modeled it to use 2 countersunk m4*30MM screws
Fuente del modelo
Enlace original: Ver detalles
CC BY-SA