IronMan Start/Stop Cover
PebbleGarage
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2026-01-09 05:35:47
0
0
000Descripción
Etiquetas
Fuente del modelo
Comentarios(0)
0.1mm layer, 2mm Brim & 20% support, 15% infill. Run printer a little slower(85%) Props to scottyboy1129 for model 360747
File and Prints of models not to sell or resale
Print Settings
Printer:
gMax Xt+
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
15%
Filament:
JMO Technology PLARed
Notes:
I tried a new filament and not happy with it. Another filament would work better. Printed 0.1mm layer w/ a 2mm brim, 20% support & 15% infill. Slow your printer down to about 85% feed rate. I used a paper clip heated to open the hinge holes, then cut a piece of the clip to use as the pin. Last, use thin double sided tape applied to the back of the ring & trimmed accordingly.
Etiquetas
Fuente del modelo
Enlace original: Ver detalles
CC-BY