Summary

Read more about about this print: https://www.funkyton.com/print-your-own-backgammon-set/

Scaled up 50% in width and depth, with a custom height. Holes made for 4x2mm magnets. Based on @Modellaner's version.

Required print volume: 155mm x 250mm

Full board size: 242,5mm x 306mm x 13,5mm

Tiles can be squeezed in to a very tight friction fit, however this will cause stress on the plastic. I inserted the green tiles with force, but decided to sand down half a millimetre of the bottom of the red tiles, and it was still a tight fit. You might have to fiddle a bit around with these depending on your printing resolution and type os plastic used.

For more designs visit: https://funkyton.com/tag/3d-printing/