I wanted a way to display my comics so I made a few low-profile, flush fitting wall mounts.  

  There are two different depths (.275" and .57").  The thin version should fit most bagged and boarded comics; the thick version should fit small and medium slabbed comics.

  Each depth variant has a cutout for a medium (.63" width) and large (.75" width) command strip.  Side note: The .75 width version works well with the medium picture hanging strips.

  These were intended to be printed with resin so your mileage may vary in other mediums.  They can be direct printed on the platform.  Side note: make sure your resin is cleaned and very well-cured otherwise the adhesive strip might not stick.

I hope you enjoy.  Feel free to use and remix according to the Creative Commons license just please attribute back to this page.