I wanted a smaller camera mount for my Blade Inductrix while still using the stock camera since it's not bad. I threw this together using an existing base. The camera should be at a 15 degree tilt. You'll note I'm not using the stock Inductrix Flight Controller since I fly FrSky, but that shouldn't matter.

The lens portion of the camera doesn't have any mounting holes so I just used double sided foam tape to stick it to the mount and that's holding up well.

I don't fly this as much as my E010s with a low profile mount but it's been through a few crashes with no damage.

FlashForge

Creator Pro

Yes

Doesn't Matter

.20

I printed on a FlashForge with standard settings.