The stock dampers on the speedometer of my DR650 had started to flatten out, causing excessive movement of the speedometer housing. I had some TPU 95A filament, so I modeled up Version 1. Upon installing, I discovered that the 95A filament was far too stiff to install, so I modified the design to closer match the original part, which would hopefully make installation easier. These were still fairly difficult to install, requiring a lot of pressure and poking/prodding to get the damper installed in the bracket, but they fit well and restore the amount of play in the original mount. 

Printing version 1 is not recommended unless you're using a much softer filament than 95A.