For some reason, Colgate Toothpaste tubes have a really small cap, and where with other brands you can naturally put them on your shelve standing upright, with Colgate it's a balancing act, especially if you also have a squeezer frog ( https://www.printables.com/model/813815-tube-squeezer-frog-no-supports-needed ) - and don't dare to hit the shelve if you managed it!

So this small print (~13g of filament, including supports) solves this issue by offering a precisely measured hole for the toothpaste to sit in. The hole has 3 drains to prevent moisture from building up when placing a wet cap inside and three feet to prevent stale water from remaining between the part and your shelve. 

I recommend to print it upside down, with support only really needed for the internal section.the outside curve is deliberately designed to be printable without support.

Source File included as always :)

Also, yay, my 50th published model on this platform! 🥳