Remote control holder I made for my living room coffee table. I designed it for smaller remotes like a FireTv Remote. Holds 6 remotes with a spot in the center for batteries or whatever else.

I added one for larger remotes that holds 5 remotes. I did not have a remote to use for measurements so not sure how good the fit is for that one.

• No supports needed.

• I used 5% infill.

• The .stl file will need to be scaled up to 1000%.

Voxelab Aquila X2

Doesn't Matter

No

.2

5%

.stl file needs to be scaled up from 100% to 1000%.