Gravity fed auto feeder for Guinea Pigs (or other small animals).
Two sizes, 150mm tall and 200mm tall.

Update: The feeder works great - the Guinea Pigs however, like to dig in the bowl until 1/4 of the bin is out on the ground. So...... depending on your rodent of choice, you might find this lets them waste a lot of food. :(

GGREINERhas made a nice addition to the feeder. ALIDmade for flexible filament, to cap the top so the animals don't climb in and dig around. :o) Thanks GGriener!

Ultimaker

Ultimaker 2

0.8noz x 0.5 layer

15%

This is large. It' takes 1/4 roll of filament (260 grams). It's the first time I've used my 0.8 nozzle. With my largest nozzle and 0.5 layer, it still takes 4 hours to print. rnNo supports needed. I've found that printing with such large settings makes 1st layer adhesion even more difficult. I had to break out my FLEKS3D build plate, then my 1st layer held fine.