Needed a new button as ours broke. Found this remix: https://www.thingiverse.com/thing:3106764 Looking at the remixes found this one that indicated that the previous version needed some reinforcement. https://www.thingiverse.com/thing:4067322

I printed it and had one of the tabs break off before I could even install it. Used tinkercad beefed up that area considerably. Will require removing the ring pin and reinstalling after the button is in place.

Have yet to install as my zip tie fix is holding at the moment.
Update: After trying to install, realized that a lot of trimming was needed, button was in the wrong spot for my Fizzi. I got it to work,but lost a bit of its integrity. I found this one https://www.thingiverse.com/thing:4949796 after doing another search. It works great! If you have a Sodastream Fizzi, DO NOT print mine, print this one https://www.thingiverse.com/thing:4949796 .

Creality

CR-10 Mini

Doesn't Matter

Yes

.2

60% gyroid

Did concentric first layer for aesthetics.
Tree support.
Branch angle 60
distance 2mm
diameter 1mm
branch diameter angle 10
collision resolution .2mm
touching buildplate
overhang angle 75
density 3%
top distance .2mm