Hulk Tap Handle
Celeste Michael
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2025-12-08 17:51:33
0
0
000Descripción
Etiquetas
Fuente del modelo
Comentarios(0)
A Hulk Tap Handle I made for my kegerator. I printed in PLA at 75% with support. The hole in the bottom is for a tap handle insert. Print, remove the support including the support inside the hole in the bottom, and thread in the insert. If the hole is too small, heat up the insert and you can thread it in hot because it melts the PLA.
Print instructions
Category: Kitchen & Dining
Etiquetas
Fuente del modelo
Enlace original: Ver detalles
CC-BY