While trying to print a large ABS piece, I had issues with the build plate itself warping off the bed (the model stuck to the plate just fine). I've made these to prevent that happening again.

Print with at least 3 walls. Consider ABS the bare minimum material to print this in; ASA would be better, and PC or PA even better again.

Attach by placing the top (shorter end) into place first, then bending the lower end into place. Finally, push it inwards towards the bed. Attach in the positions shown in the photo.

Want longer ones? Just scale them up on the Z axis!

Likely also compatible with the AD5M and AD5M Pro.

Note: Remove these clips while running the auto levelling!