I designed this mount to pressure fit a Tile Sticker (2020 version) on my cat's collar. The design is meant to be print-in-place, which means I pause the print midway through and put the collar on it, allowing the print to finish around the collar. The collar is designed to hang at a bit of an angle so it faces more downward so it doesn't bother the cat as much. Designed for a collar of 10mm width, but can probably fit a larger collar if necessary.

Printing Instructions:

Print at 0.2 or 0.3 layer height. A brim may be necessary if you have adhesion issues. Pause print at ~87 layers (at 0.2) or ~57 layers (0.3) and put the collar between the uncompleted loops. Finish the print and remove from print bed. Press Tile into the mount and apply collar to cat as directed.

Recommended to print in glow-in-the-dark so you can spot your feline friend at night or in dark areas.