A small and portable container for powders. The lid can also be twisted to align through holes, which can be used for dispensing the powder.

The model was created in onshape, the workspace can be viewed here.

Printing instructions

• No specific requirements regarding the material or print options, regular PLA with 0.2mm layer height should work just fine.
• The printer should be pretty well calibrated so that the inner and outer thread would engage without too much friction, and when the lid is in the closed position, the powder should not spill out.
• The lid should have a bit of friction when twisting between open and closed positions, so that it does not open accidentally. If your print is too loose, try adjusting XY compensation in your slicer.