Wall-mounted flower pot attached with 2 Phillips screws, printable without supports. Its clean, ribbed design fits into both modern and rustic interiors.

Holder: A small part that you screw onto the wall. It has 2 holes with a diameter of 4 mm.
Flower pot: The pot itself, which has a groove on the back. Simply slide it onto the wall mount. The flower pot is 105 mm high and 95 mm wide. It is large enough for plants to comfortably spread their root system while maintaining a relatively low printing time.

Thanks to this system, you can easily remove the flower pot at any time, water it comfortably in the sink (without dripping on the wall) or repot the plant, and then simply put it back.

The model has been tested and works perfectly. It does not leak or seep water when watering.