I remixed this from Adeema's camera mount for the Ender 3. That mount worked great but I installed a CR Touch and it was just barely too thick, causing the x axis to grind when trying to home. This one fits in on the side of the case on left side of the x axis and is screwed in tight with an M2 screw, anything 12mm or longer.

I double sided sticky taped my ESP32 cam to the flat end facing the extruder, and it works great.

Requires an M2 x 12 screw to tighten, and some double sided sticky tape

Creality

Ender 3

No

No

0.2

50%