LCR-T4 Case for original or customized version like mine with ICSP connector from bottom side and micro switch replaced by rotary encoder. ICSP pins are reversed - special cable reduction is required.

Original project: https://www.thingiverse.com/thing:1212733

More info here: https://www.mikrocontroller.net/articles/AVR\_Transistortester

This is remix of: http://www.thingiverse.com/thing:896665

Rottary encoder upgrade:
official project document: https://www.mikrocontroller.net/wikifiles/8/8f/Ttester\_eng111k.pdf
latest firmware: https://www.mikrocontroller.net/svnbrowser/transistortester/Software/trunk/ (folder mega328_T3_T4_st7565)

LCR-T4 schematic: http://www.mikrocontroller.net/attachment/228473/TT-CN\_T4.PDF
German forum: https://www.mikrocontroller.net/topic/248078

Print instructions

Unassociated tags: LCR tester

Category: Electronics Summary

LCR-T4 Case for original or customized version like mine with ICSP connector from bottom side and micro switch replaced by rotary encoder. ICSP pins are reversed - special cable reduction is required.

More info here: https://www.mikrocontroller.net/articles/AVR\_Transistortester

This is remix of: http://www.thingiverse.com/thing:896665

Rottary encoder upgrade:
official project document: https://www.mikrocontroller.net/wikifiles/8/8f/Ttester\_eng111k.pdf
latest firmware: https://www.mikrocontroller.net/svnbrowser/transistortester/Software/trunk/ (folder mega328_T3_T4_st7565)

LCR-T4 schematic: http://www.mikrocontroller.net/attachment/228473/TT-CN\_T4.PDF
German forum: https://www.mikrocontroller.net/topic/248078

Print Settings

Printer Brand: RepRap

Printer: Rebel II

Rafts: No

Supports: No

Resolution: 0.3mm

Infill: 40%

Notes:

Sliced in: Slic3r 1.1.7
Nozzle: 0.4mm
Filament: PLA 1.75mm (http://www.filament-pm.cz/en/)