Holder for the DYN DYN2806 Dynamite 5 pc Metric Nut Driver Assortment you can get on Amazon.

I found a few different versions but they were too big and bulky or didn't look like they would hold the drivers straight. I wanted something pretty solid that could sit on a desk, in a toolbox or hang on a wall.

Holders are tapered for a snug fit so you can use this on a desk or mounted to a wall. The 3 smaller sizes fit from the top-down or clip-in.

The slots are a friction fit so these are held very well.

There are two versions. One with a back-plate and one just the holder that you'll need to drill holes-in to mount.

Back is a little thicker than required but I like the weight of it.

Can be printed flat as the overhang is not that bad on the cones.

Print Settings

Printer:

FLSUN i3 2017 Version

Rafts:

No

Resolution:

25%

Filament: Amazon Basics PLA Orange

Notes: