Organize your Prusa Control!

adapter to install the LCD assambly under a shelf.

Installation:
I ran my wires up and out of the electronics box and further up, flat against the back of the frame.
To cover the gap from the printer to the shelf I used some cable sleeve, similar as the one provided with your printer.
Honestly, I don't even notice de bundle going up anymore.

Simply unscrew the LCD from the frame and leave the legs attached. The legs house the nuts and they will be re-used.
Attach the adapters to the legs, mind the orientation, see pictures below. Attach the assembly to the shelf using 2-4 wood screws

The gap to my shelf is 15cm and I still have cable left, so I estimate the shelf could be up to 25 cm.

Print instructions

printed at 0.2 with PLA with 15% infill proved sturdy enough.