POLYCARBONATE REQUIRED. PLA/PETG/ABS ARE FIRE HAZARDS.

I modified the design to have reduced wobble, sturdier legs and a rounded aesthetic that matches the design of the dryer.

I tested my polycarbonate heat shield for 4h at 70C and didn't see any deformation, but your mileage may vary. Print at your own risk.

If you have some Garolite/G10 its probably a good idea to follow Michael Hathaway's advice and make this out of that since it has even higher heat resistance. Just use a respirator while cutting, you don't want shards of fiberglass in your lungs.