Hey,

this is my Remix for BBS01 and i think also for BBS02. Please still check for yourself.
Thanks to arttupii who provided the original idea for BBSHD.

I made it a little smaller and changed position of the arm to fit the smaller motors.
The protector is held by a zip tie and protects the cables very well.
Check the picture!

Flsun Q5

Doesn't Matter

Doesn't Matter

0.4

10

Supports are not really needed if your printer is able to bridge a few millimeters and the small overhang at the bottom.

I printed with 0.6mm nozzle and 0.8mm layer width and 0.4mm layer height at 220°C with 3 walls and 10% infill. 5 Bottom layers, 3 top.

That gave me a very sturdy print and only took ~2,5h.

I used Tinkercad and made few cuts, resizes and realignments to fit the BBS01.