This is a storage box for 3d printing nozzles. In the “nozzlebox main part 2” there is room for 6 mm and 7 mm thread diameter nozzles. The “part 1” has only holes for 6 mm thread nozzles. In both Versions there is room for short PTFE Tubes for hotends. 

The main part and the lid can be assembled with a 1,4 mm wire. A printed hinge didn't work with the Extrudr Biofusion I used due to high brittleness.

Contrary to my published gcode I recommend printing the two parts separately to avoid stringing between the parts.

Printing recommendations:

• infill: 15 % linear
• shells: 3
• supports: only on the inside of the lid and below the hinge pickup point on the main part
• recommended material: Biofusion or PLA