IF YOU LIKE IT, LEAVE ME A BOOST LIKE AND A COMMENT WITH THE PHOTO OF THE PRINT, IT WOULD HELP ME A LOT TO KNOW IF YOU LIKE IT...

It can be printed with any 3D printer.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 200x201.67mm in size

 You may print at higher layer heights below the Min Depth of 0.48mm

 The Max Depth is 2.2mm and the Actual Depth is 1.6mm

Filaments Used:

PLA Generic Recicled Black Transmission Distance: 0.3

PLA Generic Recicled Red Transmission Distance: 4

PLA Generic Recicled Yellow Transmission Distance: 6

This print uses 3 unique filaments

Swap Instructions:

Start with Black

At layer #8 (0.72mm) swap to Red

At layer #12 (1.04mm) swap to Yellow

At layer #16 (1.36mm) swap to Red

This slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it.

At layer #17 (1.44mm) swap to Rojo for the rest.