Summary

I needed a way to guide filament to the extruder, so I wanted to print
Anet A8 Filament Guide Arm
http://www.thingiverse.com/thing:1915337

Made by
http://www.thingiverse.com/DevDorian

but, it wouldn't fit as I have a corner brace
http://www.thingiverse.com/thing:2243664
that replaced the stand offs behind the LCD, so I made the connector thick enough to go around the three layers of the frame. I also worried it might be too wide to get around my SD Card adapter, so I shrunk its width. Which I now think was not necessary...