Note: these prints are very hacky and simple. Would not recommend printing because:

• long print time
• large amount of print material
• not straightforward assembly/tuning
• lack of stress-testing.

Requires 

• 5A drum stick for mounting
• Tape (for wrapping around the drum stick)
• Adhesive/glue for construction

Recommended

• Rubber mallet for lightly hammering in drum stick 
• Using against a wall for support/stability
• The recommended print orientation is in the .3mf file

Assembly notes

• The drum stick for mounting is friction-fit (which is strong/stable enough I guess). The hole is oversized and I gradually added tape to the stick to add thickness until I could hammer it in snug.
• KickSwivelStoppers are used for stabilizing the trigger. I printed 2 of them; they are glued on top of the main piece and press against the left/right side of the bottom edge of the trigger
• KickClampNegative is for interfacing with your kick pedal clamp. Glue to the stand based on your ideal kick pedal location. 

See picture for assembled