Summary

Couldn't find exactly the pieces I needed to build a plexiglass stand alone enclosure around my Kossel Mini, so created some quickly myself. The legs will raise enclosure 5cm above the bottom of printer so the electronics below is not overheated. I have legs on the printer that are about 15mm high. So please cut 15mm off legs if you do not have legs below printer.
Print with atleast 20% infill.

Plexiglass Enclosure (square hole at back for filament feeder)
1x 32x60cm bakplate
1x 32x58cm door (2cm shorter to go clear of LCD display)
2x 29x60cm sideplates
1x 32x29,8cm top (used 4mm plexi)

Will post pictures when complete.

(Made a locking mechanism that can be found on http://www.thingiverse.com/thing:1760666 )

UPDATE: released v2. Bigger bolt holes and updated front legs with only one bolt hole and 2mm wider for added strength.