Details

Replacement Frame for Arfun Pro 95mm. I broke the carbon fiber frame very easily (Hit a tree branch) and needed a replacement. This frame is the exact same as the original but with thicker arms. I notice no difference with the frame. The PIDs do not need to be changed. Just hot glue the camera and beeper to the frame. I will be releasing an updated version that has a camera mount at different angles and has a beeper mount on the back. You can reuse the carbon top plate from the drone. If you would like a top plate design, comment and I will include it with the v2 frame. If you were wondering about the dirty drone, I hit a mud pit! It needs a bath!

UPDATE 11/5/18 - I have added the v2 frame, this has the same idea that the old frame did with just a small piece of carbon for the camera. I am going to test the durability of it. If it is not and breaks after a few flights, I will make a v3 that has 3 parts: Frame, camera mount, led mount.

UPDATE 12/28/18 - I received some XT30 connectors for Christmas (I highly reccond this upgrade. It makes the drone feel much faster/more powerful) and installed them on my drone. I realized that the thicker gauge wire is unable to go around the LED/Buzzer mount that was added in v2. Therefore, I have removed that mount on the "ARFUN v2 XT30.stl". To mount you LED/Buzzer board, you must either hot glue or use other means to mount to the carbon fiber top plate. CHECK THAT THE PROPS DO NOT HIT THE BOARD. I tried without checking the props and accidentally almost broke one of the LEDs.

UPDATE 6/9/19 - Made camera zip-tie holes larger.

NOTE

You may have to drill/remove some plastic from the Flight Controller mounting holes. The screws will be barely long enough. I will fix this in the v2 frame coming soon.

Print Settings

Rafts:

No

Supports:

Resolution:

Any

Infill:

Notes:

The frame may come in vertically, print it flat.

Category: R/C Vehicles