There are two models with varying thickness of the holder: 40mm and 25mm. I recommend measuring your table before printing.

You also get a screw with a thread that should work, if it's too tight, you can message me and I will make a version with a higher tolerance.

If you need a special version with different parameters, feel free to message me, as I have quite a lot of free time (for now) and I can remodel this.

You will need supports for the upper part of the holder, however the new organic supports do the job well.

I advise you to stick something anti-slip to the upper part of the holder.

And I messed up while creating these models in Fusion 360 so now they're on their sides, you will need to place them on their side using the “Place on face” tool in Prusa slicer.

This model was inspired by this item from IKEA:  

Happy printing!