Summary

Hey there,

I present my very quick mountable Hypercube magnetic printhead. I personally use it with a lot of different nozzle diameters and V6/vulcano setups. Since you are changing the whole printhead you need following components for each head:

• E3D Hotend full kit
• Radial Fan
• Cooling Fan
• Bed Level Sensor

Dowel Pins
M4 screws are used to mount the E3D Mount centered to the carriage and transmit sideways forces.

Mount the Magnets
Purchase some magnets anywhere, e.g. from Banggood. The magnets shall be glued in. Consider PETG does not bond to glue so good. PLA shall be a better option in this case. I suggest to orient the magnets with alternating polarities. Additionally I added some tape to the magnet's surface to protect them from damage but this is optional.

Materials you need
Electrics

• D-Sub 9 Female for the printer side
• D-Sub 9 Male for the printhead side

X Carriage

• 8x Neodymium Magnets (d=12x2mm)
• 11x M3 Nuts
• 11x M3x10 Screws
• 2x M4 Nuts
• 2x M4x10 Screws

E3D Mount

• 8x Neodynmium Magnets (d=12x2mm)
• 2x M3x10
• 2x M3x16
• 1x M3x20

You can find my pinout for a d-sub 9 connector in the download section.

Looking for a Fan Duct with Sensor Mount?
E3D V6 https://www.thingiverse.com/thing:1796964
E3D Vulcano https://www.thingiverse.com/thing:2433892

Some further Improvement Ideas
An integrated electric connection with pogo pins would be worth a remix. The source files are for Design Spark Mechanical