Lure Dropper needs the two parts included. I spent two days designing a practical tool for fishing if a long cast is required. The Arm clips into the mounted device. The dropper clips into Bebop 2 . Put your line with lure or bait over arm behind the stopper bar and down between the base. Close the lever run line from pole behind the bar into the slot on end of lever. Open bail and fly drown to drop Zone you select. slight tension on line with cause drone minor unstable then slight set will release line easily. Clean printed parts complete for best results. I use ABS yellow to print. Not keep cooling fan off while printing it keeps the layers welded well.

Yes

.2 or .1 layer hight is ok and .8 bottom and top layers .8 wall

25

I use brim 10-250 lines heated bed 250 c print 90 c bed fill use grid not lines.
If your good you can print both parts on one run.
Time out and go fishing were you never did from shore before.
Also good from boat if your a good Bebop 2 captain.
I use with deep sea gear and can put a fish finder way out there with out problems.