This is a model of Statoils upcoming Mariner PDQ platform, created from renderings as the platform still is at yard in Korea. The model is simplified and split to be possible to print.

Jacket can be printed standing upright without additional support, just take it slow (I printed ok at about 15mm/sec but maybe you can upp that a bit)

The platform itself is quite self-explaing, the two part are printed with the flat side down, supports are a good idea for the process equipment.

Lower part of the flare boom - print laying down. The block at the end is to make a good surface to glue on to the platform.

Upper part of the flare boom are best to print standing up.