Extremely inexpensive stringing test
cyber_forge
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2026-01-28 22:45:23
1
3
000Descripción
Etiquetas
Fuente del modelo
Comentarios(0)
This is a very simple, inexpensive, and fast-to-print stringing test.
It takes 3-4 minutes to print with a printing speed of 70 mm/s and a travel speed of 175 mm/s.
The gab is about 3 cm wide.
As a bonus, here are my retraction settings in PrusaSlicer for my Anycubic Kobra 2 with ESUN PLA+:
| Printing temperature | 207 C° |
| -- | -- |
| Use ramping lift | yes |
| Maximum ramping lift | 0.9 mm |
| Ramping slope angle | 1° |
| -- | -- |
| Retraction length | 2.5 mm |
| Retraction Speed | 65 mm/s |
| Retract on layer change | yes |
| Wipe while retracting | yes |
| Retract amount before wipe | 70% |
I found out that at the end the "Ramping slope angle" helped with stringing the most (try to keep it low), besides the nozzle temperature of course.
Etiquetas
Fuente del modelo
Enlace original: Ver detalles
CC-BY