See my M28 V2 design: https://www.printables.com/model/1364854-m28-panel-mount-v2

This mount is intended to mount an Anderson Powerpoole 15-45amp plug into a 28mm-30mm panel hole.

These connectors are typically used by amateur radio operators for 12V power.

For the pin to retain the Powerpole connect I have used paperclips, cotter pins, and wire. I have recently created the 3D printable pin and have only tested it for fit.

The washer is intended to keep the assemble from turning when mounter in a 19" 1U blank. It is not required, but you may want to adapt it for similar use.

This is a remix of my M28 Panel Blank.

Category: Hobby