Extended Endstop
designfix
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2015-11-29 06:05:30
0
0
000Descripción
Fuente del modelo
Comentarios(0)
Summary
I decided to add the new (at this time) Prusa i3 bed to my older Prusa i1. In order to do that, I needed an end stop that was recessed a tad. The endstop as shown here extends the switch out 31mm from the center of it's attached rod.
This is designed to mount to an M8 threaded rod and use an M4 screw for the clamp.
The switch mounting hole is slotted to allow you to move it up and down which should accommodate many different arm types.
Print Settings
Printer Brand:
RepRap
Printer:
Prusa Mendel
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
50%
Notes:
Printed using orange Octave ABS.
Fuente del modelo
Enlace original: Ver detalles
CC BY