This is an adjustable picture hanger, to be combined with:

• a nail whose shank can fit through the nail holder part and whose head can fit through the screw hole (not the nut)
• a #8 square nut
• a #8 machine screw
• a 3M Command strip, large size

You'll need two of these hangers attached to a wall, with the nails pointing up, to hang a picture. The screws let you adjust how far the nails stick out and you can adjust them until the picture frame is perfectly level.

No

No

0.1mm layer height

I printed this on a Formlabs Form 1 with Clear resin v2 at the 0.1mm layer height setting. I printed it directly on the plaform, flat side down, without any supports.

This was modeled in Autodesk Fusion 360. You can get the original model here: http://a360.co/1Jxg4MO.