Lampshade to be entered in the "Lights and 3D printing"-contest on the PrusaPrinters-page.

This lampshade was designed based upon a "Peony-rose".

All you need is an IKEA "Hemma" or compatible light-fixture. The lamp can be mounted hanging or standing.

Installation-manual can be downloaded
in English at http://van-opstal.be/peony-lampshade-installation-manual-en
in Dutch at http://van-opstal.be/pioenroos-lampenkap-installatie-instructies-nl

Instruction video at https://youtu.be/MhdVu1LmLJU

Print instructions

All parts can be printed without support.
Print with flat side down.
It is recommended to print (at least the middle part) in a heat-resistant material.
Overhang is limited as much as possible (no more than 65°).
Measure the socket as there seems to be some difference between the standards ...
There is a version for 36 mm sockets and one for 40 mm sockets. (only the first set is different)